How to Cope with Print Results Canon Printer 2770 No Flat

Tags

How to Cope with Print Results Canon Printer 2770 No Flat - Every printer has its own advantages and disadvantages, just like the Canon iP 2770 printer, this printer has an advantage so the price is very affordable, with a budget below 1 million we can take. Home printer Canon iP 2770 this.

Some of the most common complaints on the Canon iP 2770 printer are the uneven printouts when these printers have long been used. The cause of this uneven print job is caused by a dirty ribbon Encoder. 2 two ribbons inside a one-shaped printer about 40 cm behind the cartridge and one round on the left side. (See picture below)

How-to-Cope-with-Print-Results-Canon-Printer-2770-No-Flat
Pita Encoder Printer iP2770

The function of the band encoder

There is little to miss about this encoder ribbon function :
  • Encode the ribbon function: this ribbon has the function to align the printout horizontally. If the tape is damaged or dirty then the horizontal printout will fall apart.
  • Function band Round encoder: This ribbon has a function to align printouts in verstikal. If the band is damaged or dirty, Ribbon prints have the function to align the printout horizontally. If the tape is damaged or dirty then the horizontal printout will fall apart. Vertical gets messy and uneven. (see picture below)
  • How-Overcome-Results-Prints-Printers-Cannon-iP-2770-Mess
  • IP2770 Printer Wrong Claims Results
    How-to-Cope-with-Print-Results-Canon-Printer-2770-No-Flat
    Hasil Certakan Printer iP2770 Berantakan

    The cause of uneven prints is caused by this dirty band Encoder. The biggest case is the penetration of the ink which then fouled the tape. As for How to Resolve Print Result Canon iP 2770 You can open it and clean it, but if the damage is too severe you have to replace it with a new ribbon encoder.

    Here are the steps to clean the cannon iP2770 encoder ribbon
    • Open your Cann0n iP2770 casser printer, There are four bolts to open with a small screwdriver.
    • Once open, look in the right corner near the cartridge, Pull and release.
    • Use a soft tissue or cloth with water until wet.
    • Wipe the encoder band from top to bottom slowly until clean.
    • Warning: Try not to color the cream until the hilag, because it is cleaned slowly, clean also put back.
    • As for the round ribbon, because it is difficult to open it, you simply clean it without opening it.
    That's How to Overcome the Canon 2770 Clutter Printer, before you take it to the serviceman, but when it's done but the printout of your printer stays in a mess, it's a good idea to take it to the service before it gets worse. May be useful


    EmoticonEmoticon